Baum VarioUltra 20, User Manual, Page: 36 / 154

36
4) While the S2+D2 command will stop the transfer, there is a point
when all text has already been sent. All you can do then is to wait
until the end.
5) If you copy and paste more than 10,000 characters, only the first
10,000 characters will be sent to your mobile device.
2.5.7.2 HID Key Simulation
** New ** with v1.4:
1) From inside a Braille Notetaker application such as the Word
Processor, highlight and copy/cut a selection of text up to 10,000
characters.
2) By way of example, highlight the current sentence with command
B9+B3B6. Your highlighted sentence will display dot 8 below each
braille character.
3) If you make a mistake and wish to cancel the highlighting, enter the
cancel command B9+B7B8, or just press the D4 button.
4) Enter command c+B8B9 to copy or x+B8B9 to cut this highlighted text
to the clipboard.
5) Switch to Braille Display mode to use your mobile device such as an
iPhone
6) If not already done, activate the Bluetooth channel for the connected
device by holding system key S2 and then pressing B4, B5, B6, or B8
for the channel in question.
7) Within a text window of any application on your mobile device, press
S2+D4 on VarioUltra to initiate pasting of your copied text.
8) To stop the transfer, press S2+D5.
Note:
1) Bluetooth pairing must be initialized from the other device (iOS /
Android). If you initiated pairing in the past from VarioUltra, you will
need to remove the pairing information on VarioUltra and pair again,
only this time initiate the pairing from your other device.
2) During Bluetooth pairing and when in use, VarioUltra must be in
VarioUltra native mode (emulation VarioUltra). This is a default
setting so unless you have changed it in the past, you shouldn’t need
to worry about this step.
3) With Android: in addition to BrailleBack you must install BRLTTY for
Android 5.2 or higher.
4) In menu Settings > Braille Display Mode, option key simulation
properties you must select a HID table which matches with your
device and language, i.e. Apple_US_.U2H for iPhone.