
Operating manual for
BAUER RAINSTAR
Series TX Plus
22
Standard MENU:
SPEED 30.0m/h
DOSE 22 mm
TIME 14:10 STOP 7:43
STATUS operation
Standard display
SPEED
Speed can be changed at any time during the irrigation, using the keys „+“ und „ –“.
ZONE
Current Zone 1 – 4, with corresponding speed. The speed cannot be changed. (zone active)
DOSE
The precipitation rate is calculated by means of constants, and shows the current mm for irrigation.
If the
SPEED
increases, the
DOSE
decreases.
(
constant 11 and 12
)
TIME
To set the time: first set the speed to 11,1 m/h, and then press the
PROG
-
button 3 times to get to
<
CONST 1 TIME
>.
The time can be set with the buttons „
+“
and „
–“
. When the battery has
been removed the time is 00:00, and remains zero until it is set.
STOP
Time when the irrigation is finished incl. pre- and post irrigation
.
STATUS
Irrigation status:
<Stop sensor >
<Running >
<PRE
Irrigate
>
<POST Irrigate>
<LOW Pressure >
Explanation see STATUS chapter
If the display shows
LOW BATTERY instead of SPPED
,
the voltage in the battery is less than 11,8 V and the
battery needs to be charged.
MENU 2
DISTANCE 123m
BATTERY 12.8V
CHARGE ON 0.231A
PRE- 0:45 POST- 0:45
DISTANCE
The remaining length of the pipe. Distance can be changed immediately after pressing PROG three
times, then it can be changed with keys „+“ and„ –“.
BATTERY
Battery voltage.
CHARGE ON
Shows if the battery is charged from the solar panel. The battery is charged when the voltage is
below 14,0 volt.
PRE-
Current pre irrigation time.
POST-
Current post irrigation time.
Pre- and post irrigation time can be changed immediately after pressing
PRE
- or
POST
– with keys
„
+“
and „
–“
.