Basler A102K, User Manual, Page: 20 / 133

Camera Interface
2-4 BASLER A102
k
DRAFT
2.2 Cable Information
2.2.1 Camera Link Cable
A Camera Link compatible MDR cable assembly is available from Basler as a stock item (part #
1000013041 for a 3 meter cable and part # 1000013042 for a 5 meter cable). Alternatively, you
can use the cable assembly manufactured by 3M (part # 14X26-SZLB-XXX-0LC).
The maximum recommended length for the MDR cable used with an
A102
k
is 10 meters. It will
decrease when used in an area with severe ambient electromagnetic interference.
2.2.2 Power Cable
A Hirose, 6-pin locking plug will be shipped with each camera. This plug should be used to
terminate the cable on the power supply for the camera.
For proper EMI protection, the power supply cable attached to this plug must be a twin-cored,
shielded cable. Also, the housing of the Hirose plug must be connected to the cable shield and
the cable shield must be connected to earth ground at the power supply.
L
Note that in order to access the Integrate Enabled signal, you must use the Basler
stock cable (see Sect.
2.5.6 ).