Basler A102K, User Manual, Page: 119 / 133

Troubleshooting
BASLER A102
k
6-1
DRAFT
6 Troubleshooting
6.1 Fault Finding Using the Camera LED
When the power supply to the camera is switched on, the LED on the back of the camera will
become orange colored for several seconds as the microprocessor in the camera boots up. If
bootup is successful, the LED will then remain orange continuously.
Once bootup is complete, the camera performs a continuous series of self checks. If an error
condition is detected, the LED will begin to flash between green and orange. The number of
flashes indicate the detected error (see Table 6-1). If several error states are present, the LED
outputs the error codes in succession.
If the status LED on the back of the camera is not lit, it means that power to the camera is not
present or is less than 10.8 Volts.
LED Description
On
Continuous The camera is OK.
3
flash
es
ExSync has not changed state for 5 seconds or longer. If you are not supplying
an ExSync signal to the camera, this is a normal condition and should be ignored.
Otherwise check the cable and the ExSync generating device.
5
flash
es
The Work Set could not be stored into a User Set.
Please contact Basler technical support.
6
flash
es
A User Set or the Factory Set could not be loaded into the Work Set.
Please contact Basler technical support.
7
flash
es
A valid list of commands was not available.
Please contact Basler technical support.
8
flash
es
The FPGA could not be configured. Please contact Basler technical support.
Table 6-1: Camera Status Indicators
L
The camera has no over voltage protection. Always observe the maximum input volt-
age given in Section
2.8 .