8
Functions in the display mode
The display mode contains six functions:
OVERVIEW
,
MAIN MENU
,
CONNECTION
TIME
, shortcut to
TEMP
menu and set point, shortcut to
LANGUAGE
menu and
STANDBY MODE
.
30 seconds after the last button press, the thermostat always returns to display
mode, irrespective of where in the menus you are. If you are ever unsure of whether
you are in the required menu or setting, you can always let the thermostat return
to display mode; no settings are then saved (if you have not pressed to conirm),
and you can start again from the beginning.
Overview
[press
3s]
To quickly and easily gain an overview of the thermostat settings, press
for three seconds to activate the overview function. You can then use
and
to browse through the thermostat settings. To return to display mode,
press
or wait thirty seconds.
Main menu
[press
]
When the thermostat is in display mode, press
to go to the main menu.
From the main menu, you can reach all settings (read more about the main
menu under the section for the selected operation mode). To return to the
display mode, wait thirty seconds or
EXIT
.
INTRODUCTION
Display mode
The display mode is the thermostat's "normal" mode; the most important
settings, statuses and functions are shown and set here. The display shows,
alternatingly, the set point and current values at the same time as it always
shows the operation mode and if the installation is switched on or of. The
set point is the desired value, whereas the current value is the temperature or
moisture status at this point in time.
PROGRAM
OPERATION MODE
SET POINT
ON or OFF
CURRENT VALUE A*
HEADING
CURRENT VALUE B*
CURRENT VALUE C*
* CURRENT VALUE A shows the temperature at sensor A and CURRENT VALUE B shows
the temperature at sensor B. CURRENT VALUE C shows whether moisture is detected by
sensor C. The current value is only shown for the sensors that are installed and activated.
ON or OFF