21
Summer and winter settings are in the
MAIN MENU
under
SYSTEM
; select
S/W TIME
.
Switch of the function under
ON/OFF
in the menu and select
OFF
, a message is
shown for a short time conirming that the function is switched of. Activate the
function in the opposite way by selecting
ON
.
Sensor settings
SENSOR
The sensor settings are in the
SYSTEM
menu under
SENSOR
, and there select the
sensor you want to use by browsing with
or
and conirm with
.
The thermostat works as a Room thermostat and measures the temperature using
a room sensor. When the thermostat is used to regulate cooling, the room sensor
can be installed either as
A
or
B
. It is only possible to use one sensor at a time, but
if there are two sensors installed you can switch between
A
and
B
.
Adaptive function
ADAPTIVE
The thermostat has a function that calculates when heating should be started to
provide the required temperature at the right time. The function is activated on
delivery, but can be switched of as required.
You will ind the settings for adaptive function in the
MAIN MENU
under
SYSTEM
,
and there you select
ADAPTIVE
. Switch of the function under
ON/OFF
in the menu
and select
OFF
, a message is shown for a short time conirming that the function is
switched of. Activate the function in the opposite way by selecting
ON
.
Ventilation mode
VENT
If the room temperature increases by more than 3°C in a minute, for example, when
airing, ventilation mode is activated. The thermostat then deactivates heating for
15 minutes, after which it returns to the same setting; ventilation mode shows in
the display when it is activated. The function is activated on delivery, but can be
switched of as required.
You will ind the settings for adaptive function in the
MAIN MENU
under
SYSTEM
,
and there you select
ADAPTIVE
. Switch of the function under
ON/OFF
in the menu
and select
OFF
, a message is shown for a short time conirming that the function is
switched of. Activate the function in the opposite way by selecting
ON
.
Reset
RESET
There are three choices under the reset menu:
CONN TIME
,
OP MODE
and
FAC SET
.
You will ind the
RESET
menu under
SYSTEM
in the
MAIN MENU
.
Reset connection time
CONN TIME
The connection time is shown in hours; as with a vehicle trip meter, it shows the
number of hours an installation has been connected for since it was last reset. This
is beneicial if you want to calculate the energy consumption for a certain period.
The thermostat also has a counter that cannot be reset, which shows the total
hours the installation has been connected for.