29
Set the required max temperature by pressing
or
and conirm with
,
then set the required min temperature in the say way. The values can be set with
an accuracy of 0.5 degrees, and the factory settings are max +2°C and min -10°C.
Both max and min temperatures can be set b10°C and -20°C.
Two sensors can be installed on the thermostat. If two sensors are used
simultaneously, the temperature must be within the set range for
both sensors
for the thermostat to be activated.
Program menu
PROGRAM
In Operation mode
MAX/MIN
, there is a timer program that makes it possible to
customise snow melting further in order to save energy.
You will ind
TIMER
under
PROGRAM
in
MAIN MENU
.
Timer
TIMER
A smart way of saving energy is to adapt snow melting to your needs over a
24-hour period. Up to four on and of switchings can be programmed in the timer
program, i.e. it will only be active during certain periods of the day or during
certain days. There are three menu alternatives to choose between:
ACTIVATE
,
EVENTS
and
RESET
.
The
TIMER
function is under
PROGRAM
in the
MAIN MENU
. To start the timer program,
select
TIMER
and then
ON
; to switch of the timer, select
OFF.
When
OFF
or
ON
have
been selected, a message is shown for two seconds conirming that the function
has been activated or deactivated. In the factory settings, the temperature alarm
is deactivated.
ACTIVATE
The program is started with the activate function, and it remains active until
another program is started. The irst time the program is run, the times must be
set under
EVENTS
. All the settings are saved in the memory and are not lost even
if a power cut occurs, but, in this case, the clock must be reset to obtain normal
functionality again.
EVENTS
To set the
TIMER
program, go to
CHANGE
or
EVENTS
. There are diferent ways of
setting the various program events: you can choose to program day by day,
weekend (Saturday and Sunday) or the whole week. It is normally easiest to set
the whole week irst and then adjust this for the days requiring a diferent setting.
When you have selected the day(s), set the number of events (max 4) and the
times during the day they shall occur. Browse with the
or
button to
change the number events, and conirm using
.
To set an event, start by setting the time, which is blinking. Browse with the
or the
button to the time you want the event
ON
to occur. First set hours,
confirm with
, then minutes, confirm with
. Repeat the steps above to
set
OFF
.