Baroness LM551B, Owner'S Operating Manual

Page: 158 / 172

LH52
・
LS62
A
B
oxie9a-016
Adjustment of Mower Stoppers for Mower Unit #4 and
#5_002
A LS62
B LH52
On a level surface, lower all mower units.
Depress the locking pedal while firmly
depressing the brake pedal to lock it.
Stop the engine.
Follow the steps below to adjust the mower
stopper position.
Remove the cotter pin and washer.
Install the roller shaft and rubber roller in
the specified position.
Attach the cotter pin and washer.
3
1
4
2
4
3
oxie9a-006
Adjustment of Mower Stoppers for Mower Unit #4 and
#5_003
1 Rubber roller
2 Roller shaft
3 Cotter pin
4 Washer
LS66
For the mower unit LS66, the adjustment is
not required.
1.
2.
3.
4.
[1]
[2]
[3]
Change of Coolant
Caution
Do not touch the radiator or coolant during
engine operation or immediately after the
engine has been turned off.
Otherwise, you may get burned.
Caution
Change coolant after the engine has well
cooled down.
Caution
The radiator cap is pressurized.
If you remove the radiator cap while the
engine is overheated, hot steam will burst out,
possibly resulting in burns.
Make sure that the water temperature and
pressure are reduced, and then grab the cap
with a thick cloth and gradually open the cap.
Important
When changing the coolant, be sure to drain it
into a container and discard it in accordance
with local laws and regulations.
Important
When changing the coolant, be sure to mix
clean water and antifreeze (long-life coolant),
and then pour it into the radiator and reserve
tank.
Important
Tightly close the radiator cap.
If the cap is loose or incorrectly installed, the
engine will be overheated due to water
leakage, resulting in engine damage.
When mixing antifreeze and clean water, refer
to "Relationship between concentration of long-
life coolant (LLC) and freezing temperature"
below for the mixing ratio.
LM551B
Maintenance
Page 5-44
Maintenance Work