Baroness LM551B, Owner'S Operating Manual

Page: 65 / 172

Note:
When the mower units are raised, the reel
cutters (cutting cylinders) stop rotating even if
the reel rotation switch is set to the "Rotation"
position.
Throttle Knob
The throttle knob is located in the operation
panel and enables you to adjust the engine
rpm.
Move the throttle knob toward the "High speed"
position to increase the engine rpm, and
toward the "Low speed" position to reduce the
rpm.
1
A
B
ef6hsk-022
Throttle Knob_001
1 Throttle knob
A High speed
B Low speed
DPF Auto Regeneration Inhibit Switch
Caution
Normally, set the DPF auto regeneration
inhibit switch to "Auto regeneration mode".
However, when operating in a location where
fires may occur, set the DPF auto
regeneration inhibit switch to "Auto
regeneration inhibit mode".
Caution
Do not use the switch during back lapping.
Important
The DPF auto regeneration inhibit switch is
reset to "Auto regeneration mode" when the
engine is started even if the engine was
stopped with the DPF auto regeneration inhibit
switch set to "Auto regeneration inhibit mode".
Important
In "Auto regeneration inhibit mode" any DPF
regeneration of "Auto regeneration", "Parked
regeneration" and "Manual regeneration" is
inhibited.
For DPF regeneration, deactivate "Auto
regeneration inhibit mode".
The DPF auto regeneration inhibit switch is
located under the underseat cover.
The DPF auto regeneration inhibit switch is the
switch for shifting between "Auto regeneration
mode" and
“
Auto regeneration inhibit mode".
With the engine running, press this switch to
shift between "Auto regeneration mode" and
“ Auto regeneration inhibit mode".
Auto regeneration mode:
The DPF auto regeneration inhibit switch is
reset to "Auto regeneration mode" when the
engine is started.
In
“
Auto regeneration mode" DPF
regeneration is automatically performed
regardless of the main vehicle's travel and
stop on the condition that a specific amount
of PM is accumulated and the requirements
for DPF regeneration are fulfilled.
Auto regeneration inhibit mode:
In order to set to
“
Auto regeneration inhibit
mode", press the DPF auto regeneration
inhibit switch after the engine is started.
In
“
Auto regeneration inhibit mode" PM
accumulates in the DPF and PM
accumulation level increases.
Unless the operator deactivates auto
regeneration inhibit mode on his own will,
regeneration is not performed.
1
jvex95-013
DPF Auto Regeneration Inhibit Switch_001
1 DPF auto regeneration inhibit switch
･
･
Handling Instructions
LM551B
Handling Instructions
Page 4-35
Operation Method