1
Push-pull cable
2
Adjuster nuts
3
Pedal mount
Insert the push-pull cable, and then install
the washer and cotter pin.
3
2
1
hsn2jo-003
Adjusting the Neutral Position of the Piston Pump_005
1
Push-pull cable
2
Cotter pin
3
Washer
Change of Fuse
Important
When performing maintenance on the
electrical system, be sure to remove the
negative battery wire.
Important
If a fuse blows, a short may have occurred
within the electrical circuit.
Check for the cause, such as faulty terminal
connections, damaged wiring or terminals, or
incorrect wiring.
Important
For fuse replacement, clean the fuse
mounting area with use of compressed air
before mounting the fuse.
9.
Fuses
Fuses are located in the lower right corner
behind the front cover and consist of the main
harness fuse for the entire circuit.
It is a mini blade fuse 20 A.
1
4pnauw-006
Fuses_001
1
Main harness fuse
Towing
Towing the Machine in An Emergency
If the machine does not travel due to engine
trouble, etc., you can move it in the following
ways:
Pushing by hand
Towing (See the following instruction.)
Caution
Unless you plan to tow the machine, raise the
bolts so they do not contact the unload valve
operating pins, and then tighten the lock nuts
firmly.
Caution
Before restarting the engine, be sure to close
the unload valve.
Important
When towing the machine, travel at a speed
no more than 3.0 km/h.
In addition, do not tow the machine for more
than 3 minutes.
If the towing speed is too fast or the machine
is towed too much, the pump or motor will be
damaged.
Stop the engine.
Apply the parking brake.
Chock the wheels.
･
･
1.
2.
3.
FS900
Repair
Page 7-4
Towing
