Barco ZEUS, Installation And Safety Manual

Page: 12 / 189

2. Safety
2.3 Important safety instructions
To prevent the risk of electrical shock
• This product is equipped with a three-terminal barrier strip for the connection of a mono phase power line with a separate
earth ground PE. If you are unable to install the AC Requirements, contact your electrician. Do not defeat the purpose of the
grounding.
• The cross-sectional area of the conductors in the power supply cord shall be not less than 2.5mm
2
(12AWG) , minimum 300V.
Take into account that the cable gland of the projector allows a cable diameter from 8 to 13 millimeter.
• A readily accessible disconnect device must be incorporated externally to the equipment for removal of the power to the pro-
jector mains terminals.
• High leakage current. Earth connection essential before connecting supply.
• Ensure that the mains voltage and capacity matches the projector electrical ratings.
• Installation according to the local electrical code and regulations by quali fi ed service personnel only.
• Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on the cord. To disconnect
the cord, pull it out by the plug. Never pull the cord itself.
• Do not operate the projector with a damaged cord. Replace the cord.
Do not operate the projector if the projector has been dropped or damaged - until it has been examined and approved for
operation by quali
fi ed service personnel.
• Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.
• If an extension cord is necessary, a cord with a current rating at least equal to that of the projector should be used. A cord rated
for less amperage than the projector may overheat.
• Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out
parts that could result in a risk of
fi re or electrical shock.
• Do not expose this projector to rain or moisture.
• Do not immerse or expose this projector in water or other liquids.
• Do not spill liquid of any kind on this projector.
• Should any liquid or solid object fall into the cabinet, unplug the set and have it checked by quali fi ed service personnel before
resuming operations.
• Do not disassemble this projector, always take it to quali fi ed service personnel when service or repair work is required.
• Do not use an accessory attachment which is not recommended by the manufacturer.
• Lightning - For added protection for this video product during a lightning storm, or when it is left unattended and unused for long
periods of time, remove all power from the projector. This will prevent damage to the device due to lightning and AC power-line
surges.
8 R5905961 ZEUS 09/03/2015