Barco R9841020 Cine VERSUM Master, Installation Manual

Page: 147 / 161

20. Cine VERSUM Master Settings & Info
20.4.3 Selecting the Transmission Speed
How to set the transmission speed of the RS232 connection
1. Select item
SERIAL COMMUNICATION
in the Service menu by rotating the jog dial on the Master or the ↑ or ↓ keys on the
Remote Control.
2. Press the jog dial on the Master or the key ENTER on the Remote Control to confirm.
The sub menu SERIAL COMMUNICATION appears on-screen and in the graphical display, including the possibility to set the
Baudrate (transmission speed), the Interface standard RS232/RS422 and the RS422 termination. (menu 20-7)
3. Select item
BAUDRATE
in the Serial Communication menu by rotating the jog dial on the Master or the ↑ or ↓ keys on the Remote
Control.
4. Press the jog dial on the Master or the ENTER key on the Remote Control to change the Baudrate value between brackets.
Note: Make sure that both the projector and the computer are set for the same Baud rate. Refer to the computer’s operation
manual for instructions for setting the Baudrate.
5. Press EXIT on the Remote Control or select
BACK
in the graphical display menu, rotating the jog dial to select and pressing to
confirm, to exit the GUI.
Serial Communication
Baudrate [115200]
Interface: [RS232]
Termination: [On]
Back
Menu 20-7
20.4.4 Selecting the Interface standard (RS232/RS422)
About Data Transmission
Standards have been developed to insure compatibility between units provided by different manufacturers, and to allow for reason-
able success in transferring data over specified distances and/or data rates.
RS232: Single-ended Data Transmission. The specification allows for data transmission from one transmitter to one receiver at
relatively slow rates (up to 20K bits/second) and short distances (up to 50Ft.@ the maximum data rate).
RS422: Differential Data Transmission: This standard was designed for greater distances and higher Baud rates. Data rates of up
to 100K bits/second and distances up to 4000Ft. can be accommodated with RS422.
How to set the interface standard
Refer to the manual of the connected control unit about the data transmission standard to be set.
1. Select item
INTERFACE
in the Serial Communication menu by rotating the jog dial on the Master or the ↑ or ↓ keys on the Remote
Control (Selecting the Transmission Speed, page 143.). (menu 20-8)
2. Press the jog dial on the Master or the ENTER key on the Remote Control to change the Interface standard between brackets
to RS232 or RS422.
3. Press EXIT on the Remote Control or select
BACK
in the graphical display menu, rotating the jog dial to select and pressing to
confirm, to exit the GUI.
Serial Communication
Baudrate [115200]
Interface: [RS232]
Termination: [On]
Back
Menu 20-8
R5976468 CINE VERSUM SYSTEM 03112003 143