Barco MES ACURAS HEAD, User And Installation Manual

Page: 60 / 131

8. Getting started
User defined
Calculated, then changed
Calculated
Visible image area
Image 8-31
Acuras multi point: panel markers
In case of rear projection or ceiling mode, the ordering might be rotated or mirrored.
Gimbal positions
After the de fi nition of the Panel Markers, the user must de fi ne the corresponding Gimbal positions for each of the Panel Markers.
As soon as a Gimbal position is stored, the corresponding Panel Marker turns green.
If a Panel Marker is changed after the de fi nition of the Gimbal positions, the nine Gimbal positions must be rede fi ned.
1 1-2
3-4
2
2-4 1-3
4 3
C
Gimbal positions numbering
Image 8-32
C
Gimbal Centre
1 Gimbal Corner 1
2 Gimbal Corner 2
3 Gimbal Corner 3
4 Gimbal Corner 4
1-2 Gimbal Side 1-2
1-3 Gimbal Side 1-3
2-4 Gimbal Side 2-4
3-4 Gimbal Side 3-4
8.5.2.2.2 De fi ning the Panel Markers
Introduction
By default, fi ve Panel Markers must be de fi ned. Optionally, the position of two of the automatically calculated Panel Markers can be
changed.
If you have de fi ned multiple Head Location in the Options page, then manually position your Auto Alignment
Head corresponding to the head location of Auto Alignment Head in the display prior to de fi ning the Acuras
Multi-point position.
How to de fi ne the fi ve main Panel Markers?
1. Project any image or internal pattern.
2. On the Positioning Page, navigate Position > Position type and select
Acuras Multi-point from the drop down list.
52 R59770509 MES ACURAS HEAD - AUTO ALIGNMENT HEAD 24/11/2010