Barco MES ACURAS HEAD, User And Installation Manual

Page: 100 / 131

9. Operating Acuras
Acuras Realignment requires a spurious light free system. Before using it, all light on the screen other than the projector light should
be eliminated.
The best practice is to always run the Acuras realignment on all projectors in the selected group in order to
achieve a good result.
By default, the patterns on which the automatic brightness and color measurements are performed are gener-
ated in the projectors. It is however possible to use the AutoGeometry IG testpatterns through API commands.
See R59770566 — API Commands for XDS RACU Software.
How to start Acuras Realignment process?
1. Select a projector to be realigned from a group.
2. Navigate to the Light Output page and activate the required Golden Alignment set.
Image 9-13
activating a golden alignment set
Note: Acuras realignment can only be executed when a Golden Alignment for which Acuras capture has been executed is
activated. The last selected Golden Alignment is indicated at the top of the Acuras page.
3. Navigate to the Acuras page, and make either of the selections:
- If you wish to calibrate more than one projector, select the desired projectors or select all projectors in that group.
Image 9-14
selecting the desired projector(s)
- OR select group, if you wish to calibrate all projectors of this group.
Image 9-15
group selected
Note: Make sure not to select the projector(s) whose Acuras capture was not stored.
4. Optional: Check the Force gimbal reset before capture or realign checkbox.
5. Navigate to Realignment section and select the desired realignment settings. For reference see image 9-9, image 9-10, im-
age 9-11, image 9-12.
92 R59770509 MES ACURAS HEAD - AUTO ALIGNMENT HEAD 24/11/2010