8 ______________________________________________________________ Barco – ISIS LFC – Installation Guide
2.1.2
Introduction
Do not loosen any screws unless they are mentioned in this installation procedure
Rear Cover removal is necessary before replacement of the electronic modules except for
backlight and fan replacements. The Rear Cover protects and hides the display electronics for
safe handling. The Rear Cover also provides a means of fixation for mounting the display.
Four removable Backlight Cover plates at the top and bottom close the holes through which
the Removable Backlights slide. Two removable cover plates (TS-Covers) at the left and right
sides hide two Pivot feed-through holes.
For a safe handling of the display, it is strongly recommended to mount, at least temporary,
two handles as shown on the figure hereby.
Figure 2-3 Safe MDP 471 Handling
Before starting the removal/reinstallation procedure of modules and/or boards,
place the unit on an ESD safe table with the front facing downwards.
2.1.3
Tools required
1 Slotted 4.5 mm or 3/16" screwdriver.
1 Phillips #1 screwdriver.
1 Opti-sense (V5660792) for calibration
1 Barco Keypad
Firmware Download Tool and KP/Upload cable Z3498894 or equivalent (ref. description of LFC
install).
For a safe handling of the MDP 471,
it is strongly recommended to mount, at least temporary,
two handles as shown on the figure hereby.
Parts list:
2 handles R724301 FRM DLITE TILE HDL
4 screws R362153 SCR D7985 M 4 X 12 STZN
4 washers R367378 SPR D125A D 4,3D 9 STZN
SAFE MDP 471 HANDLING
MDP471UM03ADD20020128
2 x R724301
4 x
R362153
&
R367378
