Barco – ISIS LFC – Installation Guide _____________________________________________________________ 15
Note that the LFC: Enable/Disable item and the LFC advanced submenu are only
available when LFC was installed (see “LFC install”).
2.2.2.2
Advanced LFC menu (Administrator Menus)
This is a submenu in the Input Boards menu (see “Enabling/Disabling LFC
(Administrator Menus)) and is focused at the calibration of LFC.
The layout in the keypad:
LFC advanced
Submenu
LFC tables
Table:
Extern
T
Invalid
FW. ver.:
0
>
LFC Calibration<
Start:
E
Status:
>
LFC Calibration<
Upload:
E
Table
Selects the calibration table to use, there are three possibilities.
0: External,
1: Internal 1,
2: Internal 2.
External uses the calibration table as stored in flash. This table is the
result of an external calibration. Internal 1 & 2 use a calibration table as
stored in the Panel EEPROM and are the result of an internal calibration.
Internal 2 is the result of last internal calibration. Internal 1 the one
before that.
FW. Ver. Stands for firmware version.
It contains the version of the LFC firmware (the version of the FPGA code
in the Janus).
The second page is dedicated to the (Internal LFC calibration):
Start Starts/stops
the
calibration
Status
Indicates the progress.
See “LFC calibration” for more details.
The last page controls the upload of the LFC calibration software via the serial port of
the ISIS. see
Start Starts/stops
the
upload
The progress is indicated on the page
See “LFC calibration software upload” for more details.
