Barco Galaxy WARP 7 HC, Owner'S Manual

Page: 97 / 154

6. Random Access
Image 6-41
Transport Delay basic principle
How to Start up the Transport Delay ?
1. Push the cursor key ↑ or ↓ to highlight
Transport Delay
in the
Edit
menu. (menu 6-93)
2. Press
ENTER
to select.
The
Transport Delay
menu will be displayed. (menu 6-94)
GUIDED GEOMETRY MAP
COARSE
LINEARITY
FINE
SHIFT
TRANSPORT DELAY
BLANKING/SOFT EDGE
RESET
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 6-93
TRANSPORT DELAY
MODE [AUTOMATIC]
TRANSPORT DELAY = 168
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 6-94
In a set up with 1 projector skip the following adjustment procedure and always leave the Transport Delay in
the default automatic mode.
How to adjust the Transport Delay ?
The following procedure is described for a system with 3 projectors, apply the same guidelines for a multi-projector set up.
1. Make sure the 3 projectors are set to the default [AUTOMATIC] Transport Delay mode. (menu 6-95)
Each projector will automatically correct the Transport Delay to a certain value, e.g.:
Projector # Automatic Transport Delay
Projector 1 200
Projector 2 250
Projector 3 190
2. Leave the projector with the maximum value on [AUTOMATIC], in this case projector 2 with an Automatic Transport Delay of 250.
3. On Projector 1, push the cursor key to highlight
Mode
in the
Transport Delay
menu. (menu 6-96)
4. Press
ENTER
to toggle from [AUTOMATIC] to [MANUAL]. (menu 6-97)
5. Push the cursor key ↑ or ↓ to highlight
Transport Delay
. (menu 6-98)
6. Push the → cursor key to set the Transport Delay to the maximum value in the set up, in this case set the Transport Delay
manually to 250.
R5976755 BARCO GALAXY WARP™ 7 HC 05/04/2004 93