Barco Galaxy WARP 7 HC, Owner'S Manual

Page: 134 / 154

8. Service Mode
8.3 Starting Up Service
How to Start Up Service?
1. Press
ADJUST
or
ENTER
key to start up the
Adjustment Mode
.
The
Adjustment Mode
menu will be displayed.
2. Push the cursor key ↑ or ↓ to highlight
Service
. (menu 8-1)
3. Press
ENTER
to select.
The
Service
menu will be displayed. (menu 8-2)
ADJUSTMENT MODE
Select a path from
below
RANDOM ACCESS
INSTALLATION
SERVICE
Source 1
Select with
↑
or
↓
then <ENTER>
Menu 8-1
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
LAMP
MORE ...
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 8-2
Some items in the Service menu are password protected (when the password function is active). Enter the
password to continue. All other password protected items are now available if you stay in the adjustment
mode.
8.4 Identification Screen
What can be seen on the Identification Screen?
The title page screen shows the general information of the projector.
The following items will be displayed:
•
Type of projector: Barco Galaxy WARP™ 7 HC
• Proj. address
• Software version
• Configuration:
- Front / Table
- Front / Ceiling
- Rear / Table
- Rear / Ceiling
• Baudrate PC: transfer speed for communication with an IBM PC (or compatible) or MAC. The baudrate of the projector must be
the same as the baudrate of the connected computer. When there is a difference, consult ’Change Baudrate PC’ in this chapter.
• Text: Indicates if the on screen text information (picture setting textboxes: contrast,...) is enabled or not
• Projector Serial number: indicates the fabrication number of the projector. This number can be useful when calling for technical
assistance.
• Projector Run Time: gives the total run time since the first start up. All projectors leave the factory with a run time of approxi-
mately 24 hours.
130 R5976755 BARCO GALAXY WARP™ 7 HC 05/04/2004