Barco F90 - W13WUXGA, User Manual

Page: 88 / 103

9. System settings menu
9.3 Standby ECO
About Standby ECO
When the ECO mode is enabled, the projector will automatically go to ECO standby mode after a time-out (default 15 minutes).
All electronics (including fans, pumps, ...) go down except for a very small wake-up controller. See section dedicated to the Power
Mode transitions for further details.
How to enable the ECO mode
1. In the main menu, select System Settings → Standby ECO .
Image 9-2
System Settings Menu — Standby ECO
2. To enable the ECO mode, make sure the slider is set to On. The slider is enabled when set to the right and when it is colored
blue.
How to disable the ECO mode
1. In the main menu, select System Settings → Standby ECO .
Image 9-3
2. To disable the ECO mode, make sure the slider is set to Off. The slider is disabled when set to the left and when it becomes grey.
9.4 Service
About
System settings / Service
The Service Menu is for service personnel and / or advanced users only.
See the Service Manual for detailed information regarding service issues.
The menu is password protected.
9.5 Reset
What can be done?
All settings and values on the projector can be reset to its default values. This can be done for one or more settings separately, or
all settings together (factory reset).
Default settings
The following settings are default settings:
Setting Default value
UserInterface Theme Light
Network Communication LAN, Automatic settings
System Eco Mode (if applicable) Available
Screen Screen luminance - Unit nits
84 601–426 F70 SERIES 24/10/2017