Barco F90 - W13WUXGA, User Manual

Page: 20 / 103

2. Getting to know the projector.
1
1
LED Warning Indicator
1
2
Adjustable Feet
1
3
Lens
1
4
Lens Holder
1
5
IR Receiver. For receiving remote control signals
1
6
LCD Display
1
7
Keypad Panel. Used for local operation of the projector.
1
8
Connector Panel. Control and communication interfaces for the projector
1
9
Front USB and Triggerboard.
2.2 Service and Maintenance
General
The F70 series does not have any user serviceable parts.
All service tasks must only be carried out by the manufacturer, or a Barco authorized service personnel or Barco technicians.
2.3 LED Status Light
About
The F70 Status Led is located on the rear top of the Projector
During normal operation, the LED is not illuminated. In the event of a critical error or high temperature, the LED will illuminate red.
By critical error, the projector cannot be restarted until the projector is disconnected from the power supply and then reconnected
again. If the reason for the error persist, the projector will again go to critical error status.
By high temperature, the projector can be restarted when it has cooled down, and the temperature is back within the normal operating
limitations
2.4 Power on / Standby button backlight indications
Indicator
In addition to the LED indicator, the projector also displays status indications in the backlight of the Power / Standby button.
The table below shows the details regarding this indications.
Operating Status Indication Color / Behavior
On (active) Blue
Wait on Blue fl ashing
Standby (off) White
Wait White short fl ashing
Overheating Red fl ashing
Con fi gure/upgrade White fast fl ashing
Standby ECO White heartbeat
16 601–426 F70 SERIES 24/10/2017