23
Final Grill Assembly Step
When you have finished assembling your grill,
be sure that all screws are tightened for safe
operation of your grill.
Before each use of the grill, make sure the
Grease Tray is fully seated under the Grill Bowl.
CAUTION: The Grease Tray should be inspected
before each grill use to be sure there is no ex-
cessive grease buildup. Clean the Grease Tray
frequently to eliminate grease build-up and to
prevent grease fires.
(for BAI10ALP/NG & BAI10BLP/NG Models)
Cooking Rack/Secondary
Cooking Grids
Flame Tamer Rack
Flame Tamer/Ceramic,
Front
(for B3810ALP/NG & B3810BLP/NG Models)
Flame Tamer/Ceramic,
Front
Cooking Rack/Secondary
Cooking Grids
Flame Tamer Rack
Spark Electrode Tip
Spark Receiver
Spark Gap 3/16"
Gas Collector
Box
AA Battery may be installed backwards.
Electric wires may be loose. Remove the AA
Battery and inspect the Ignitor Junction Box
found behind the Control Panel and recon-
nect any loose wires.
-
-
Main Burner Electrode Check
With the assistance of another person,
perform this Electrode Check before
proceeding.
8
Be sure all Control Knobs are set to "OFF" and
open the Grill Lid.
Have your assistant stand behind to the right of
the grill and look toward the front of the grill bowl.
Never
put your face inside the Grill Head.
Push and turn Burner Control Knob to HI/ and
you will hear a "clicking" sound as the burner
is being ignited. Your assistant should see a
blue spark within each Gas Collector Box. If
a spark is present the Electrode Tips are
properly positioned.
If no spark is seen, the Spark Gap needs to be
adjusted as follows:
This test will ensure that the Spark Electrode
Tips are properly positioned so your grill lights
easily.
•
•
If the gap between the Spark Electrode Tip
and Receiver is more than 3/16" wide use
needle nose pliers to gently squeeze the
Gas Collector Box to narrow gap.
Recheck the Electrode again, if no "clicking"
sound is heard:
Infrared Burner and Rotisserie Burner
Electrode Check
9
Push and turn Infrared Burner Control Knob &
Rotisserie Burner Control Knob to HI/ . Look
for spark between electrode tip and spark
receiver tip.
If you don't see a spark from the Infrared
Burner Electrode or Rotisserie Burner, adjust
the gap between the electrode tip and spark
receiver tip to 3/16" wide.
Install Cooking Components
10
Place the Flame Tamer Rack inside the Grill
Bowl. Position it onto the lower ledge of the
Bowl above the burners. Next, place the Flame
Tamers on the Flame Tamer Rack. Make sure
the flame tamer side with the wider holes is
placed downwards. (See the diagrams on
right)
Place the Cooking Grids on the ledge above
the Flame Tamers.
Place the Secondary Cooking Rack into the
slots on Grill Bowl Side Panels.
