![Bang & Olufsen BeoVision 12-65 MK II Installation Manual Download Page 50](http://html1.mh-extra.com/html/bang-and-olufsen/beovision-12-65-mk-ii/beovision-12-65-mk-ii_installation-manual_3730928050.webp)
Scene setup
50
CONTROL TIMERS
If a Control Timer is chosen (above) the menu in the illustration to the right will be shown,
or
If the Control Timer is to be set manually do the following:
- Select
CONTROL TIMERS
>
Centre
button and the menu in the illustration to the right will be shown.
In the section
CINEMA ON
:
- Select a
CONTROL TIMER [1, 2, 3, 4]
(not already being used) and press the digit buttons for the desired value
or press the
Centre
button to the right (increasing number) or left (decreasing number) to set the timer to the
number of seconds the action related to the Open Collector should be delayed before it is started: {range 1 to
200 s}, counting from when the Home Cinema Scene is started.
Also set the Warm Up Time; see section: “Additional timer settings”
page 51
.
In the section
CINEMA OFF
:
- Select a
CONTROL TIMER [1, 2, 3, 4]
(not already being used) and press the digit buttons for the desired value or press the
Centre
button to the
right (increasing number) or left (decreasing number) to set the timer to a number of seconds the action related to the Open Collector should be
delayed before it is started: {range 1 to 200 s}, counting from when the Home Cinema Scene is ended.
Also set the Cool Down Time; see section below.
In the section
LIFT
:
- Select
CABINET SPEAKER
to specify if the centre speaker is also in the cabinet, and therefore the television and speaker(s) should be raised even in
audio only mode.
- Select
LIFT DONE DELAY to
specify the time that it takes for the lift to raise the television out of the cabinet: {range 1 to 240 s}. The electric
curtains are delayed until this time has expired. If a value of 0 (zero) is set, the LIFT DONE DELAY will be set to OFF. Please note, that if this time is
lower than the startup time for the television, the curtains will be opened as soon as possible.
In the section
CINEMASCOPE:
- Select
CINEMASCOPE ON/OFF
to control a motorised lens in front of the projector. If setting this to ON, the lens will be activated when entering
one of the two special cinemascope formats.
CONTROL TIMERS
CINEMA ON:
CONTROL TIMER 1
0s
CONTROL TIMER 2
0s
CONTROL TIMER 3
0s
CONTROL TIMER 4
0s
WARM UP TIME
0s
CINEMA OFF:
CONTROL TIMER 1
0s
CONTROL TIMER 2
0s
CONTROL TIMER 3
0s
CONTROL TIMER 4
0s
COOL DOWN TIME
0s
LIFT:
CABINET SPEAKER
NO
LIFT DONE DELAY
0s
CINEMASCOPE
OFF
select
O