BeoLab Transmitter 1 front - connection panel 4
BeoLab Transmitter 1 front
The Product Status LED is placed in the front, middle of the BeoLab Transmitter 1; see
page 18
.
BeoLab Transmitter 1 connection panel (rear side)
The WIRELESS LED is placed in the rear side above the push buttons of the BeoLab Transmitter 1; see LED indications
page 18
.
The Power Link connectors are used to connect to the source signals.
Above each Power Link input connector two LEDs are placed to give indications regarding the sound channels established to the wireless speakers.
The white LED gives indications regarding the left (L) channel and the red LED gives indications regarding the right (R) channel; see LED indications
page 18
.
The Wireless Power Link antennas are placed in the lid (top) of the BeoLab Transmitter 1, and due to the PCBs placed below this, the signal
strength is somewhat attenuated on the backside of the BeoLab Transmitter 1.
It is recommended to place the BeoLab Transmitter 1, so it is not hidden, and it must never be placed behind the TV as the metal parts will prevent
the wireless signals to reach the speakers.
The push buttons can be activated as follows; see also description of push button functions
page 17
:
- short press
≤1.5 s
- long press
≥ 1.5 s and ≤10 s (often confirmed when the LED turns solid)
- very long press
≥ 10 s
100 - 240V 50/60Hz