Connecting source systems to BeoLab Transmitter 1 12
Associating wireless speakers to the BeoLab Transmitter 1
- Connect the source output channels to the input sockets of the BeoLab Transmitter 1.
- Connect the BeoLab Transmitter 1 and all wireless speakers to the mains.
If the BeoLab Transmitter 1 and any speaker have previously been configured then do the following to ensure such is completely cleared:
- Long press on
SELECT
and
STORE
simultaneously by which cleared state is obtained.
The WIRELESS LED will become solid white and then start flashing white.
The LED on the speakers will turn solid red for a few seconds and then start flashing green, indicating ready for being scanned.
Scanning
- Short press on
SELECT
by which BeoLab Transmitter 1 starts scanning for wireless speakers.
The WIRELESS LED is fast flashing green during the scanning mode.
The white and red LEDs above the POWER LINK sockets turns solid for each speaker found. When more than 8 speakers are found only the 8 LEDs
are lit.
The LED on the speakers will first turn solid red for a few seconds and then when found it will turn to solid green, indicating ready for being
configured.
Configuring speaker position with sound channel
In the following description the configuration of the left stereo channel and of the right stereo channel is the same procedure to be used for
configuration of the left and right sound channel for each of the PL socket in a multi-channel setup.
Manual configuration
- Long press
SELECT
to start manual configuration.
The WIRELESS LED turns solid green to indicate manual configuration mode. When the
SELECT
button is released the WIRELESS LED continues fast
flashing green.
The white LED for the left (L) sound channel starts flashing. LEDs for the other sound channels are Off.
Noise is emitted from one of the speakers.
Left stereo channel
- Short press once or repeatedly on
SELECT
until the noise is emitted from a speaker that shall be configured with the left sound channel.
- If more speakers shall be configured for the left sound channel (else go to next bullet), make a long press on
STORE
, and the WIRELESS LED on the
BeoLab Transmitter 1 turns solid green, to confirm that the speaker configuration is stored for the left sound channel. When the
STORE
button is
released the WIRELESS LED continues fast flashing green.
Noise will now be emitted from another speaker and the LED for the left sound channel is flashing. Continue at the step above.
- If all speakers are configured for the left sound channel, make a short press on
STORE
, and the WIRELESS LED on the BeoLab Transmitter 1 turns
solid green, to confirm that the speaker configuration is stored for the left sound channel.
The white LED for the left sound channel becomes solid, and the red LED for the right sound channel starts flashing. LEDs for the other sound
channels are Off.
Noise will now be emitted from another speaker.