Use of ServiceTool - SW update - BeoLab Transmitter 1 19
Use of ServiceTool
The ServiceTool is used for SW update during installation - apart from that the ServiceTool is primarily used with service and repair situations.
Follow the instructions with the mode and actions chosen.
SW update - BeoLab Transmitter 1
Note: A standard USB A to USB Mini-B cable is used for connection between the PC hosting the ServiceTool and the BeoLab Transmitter 1 (Part
No.: 6270848) and also a the CDC/ACM driver must be installed. (In ServiceTool, see
Connections
>
USB Driver
).
In the
Launch
view (activate the
LAUNCH PAD
in the quick launch tray of the ServiceTool), activate the
Connections
tool, and under USB driver
activate the
Execute CDC/ACM driver installer
. Usually the PC must be restarted for the driver to work.
- Connect the BeoLab Transmitter 1 to the mains.
- Connect the USB Mini-B connector (Service) of the BeoLab Transmitter 1 to a USB A connector of the PC hosting the ServiceTool.
- Identify the Com port used on the PC by entering e.g.
Start
>
Control Panel
>
Hardware and Sound
>
Device Manager
, and under
Ports (COM & LPT)
it shows
ATI COM port (COM n)
where n is the number of the chosen Com port.
- In the lower left corner of the ServiceTool, remember to select the Com port used to connect to the BeoLab Transmitter 1.
- Select the
BeoLab Transmitter 1
in the product list and open the entries
Software
>
Automatic Software Update
.
Follow the instructions in the ServiceTool, that are:
- Press the
Read
button to see the present
Software in the Product.
-
Under
Select Software Build
, and in the
Version
drop-down list select the desired SW build and press
Update
.
The Product Status LED will be slowly flashing green during the update process.
In the Logging field, the progress of the SW update will be shown, ending by indicating the final status.