Use or USB memory stick - SW update 20
Use of USB memory stick
This function is made awailable with the SW ver. 1.1 and newer.
SW update - BeoLab Transmitter 1 and wireless speakers
Additionally to updating the SW for the BeoLab Transmitter 1 it is also possible (with SW ver. 1.1 and newer) to push SW updates to the wireless
speakers and BeoLab Receiver 1 via the BeoLab Transmitter 1.
Note: It is recommended that the USB memory stick is emptied for files and folders to avoid loss of data.
Use a computer to download the desired SW build to the root of the USB memory stick from
www.bang-olufsen.com.
Tick off the terms and conditions at the bottom of the page.
Select DOWNLOAD SOFTWARE
Extract the contents of the *.zip-file and read instructions.
[File formats supported are: FAT 16, FAT32 and filenames only consisting of 8.3 characters].
- Make sure that all speakers are mains supplied, and that the role switch is set to wireless.
- Disconnect the BeoLab Transmitter 1 from the mains for at least 60 s.
- Insert the USB memory stick into the USB A connector.
- Connect the BeoLab Transmitter 1 to the mains.
The BeoLab Transmitter 1 may restart (LED is solid red) and will continue to search for any SW builds and if a newer is found the SW for the
BeoLab Transmitter 1 will be updated automatically.
The Product Status LED will be slowly flashing green during the update process.
Sometimes two updates are initiated and the LED will be slowly flashing green during the second update process
- LEDs over the Power Link connectors will turn solid according to the number of wireless speakers connected.
The LED for the first speaker will start to blink
The green LED on the speaker will be slowly flashing green during the update process.
If the update is successful the Power Link LED turns off and the above mentioned procedure will continue for the other speakers in sequence.
If the update is not successful the LED over the Power Link connector for the actual speaker will be quickly flashing green, and likewise the
white or red LED for the sound channel will be flashing while update for the next speaker will continue.
- Regarding the speakers not successfully updated, the mains power must be switched Off both for the BeoLab Transmitter 1 and the speaker.
When mains power is On again the SW update for the speaker will be redone.
- When all updates are completed, the BeoLab Transmitter 1 restarts automatically, LED is solid red and then switches off.
- Disconnect the BeoLab Transmitter 1 from the mains for at least 60 s before removing the USB memory stick, and then reconnect to the mains.
Note: A SW update usually consist of all three updates.
A SW update will usually take from 5 to 15 minutes for each speaker, depending on environment and number of updates. Playback is not possible
during a SW update.
