Installation and wiring
5.3 Switch the link module
1. Disconnect the power supply cable to the Automation Panel (disconnect the power cable). Disconnect from
all sources and poles!
2. Carry out electrostatic discharge at the ground connection.
3. Remove the Automation Panel from the control cabinet by following the installation steps in reverse order.
4. Place the Automation Panel on a clean, flat surface.
5. Remove the Torx screws (T10) indicated in the following figure.
6. The link module can now be removed by pulling it straight up.
7. The link module can now be reinstalled by following these steps in reverse order. The max. tightening torque
of the Torx screws (T10) is 0.5 Nm.
74
Automation Panel 9x3 User's manual 2.01
