International and national certifications
10.2 Certifications
Danger!
A complete system can only receive certification if all individual components installed and connected
in it have the corresponding certifications. If an individual component is used that does not have the
corresponding certification, the complete system will also not be certified.
B&R products and services comply with applicable standards. These are international standards from organizations
such as ISO, IEC and CENELEC, as well as national standards from organizations such as UL, CSA, FCC, VDE,
ÖVE, etc. We pay special attention to the reliability of our products in the industrial sector.
Information:
The certifications valid for the respective product are available on the website and in the user's manual
under the technical data in section "Certifications" or in the associated certificates.
10.2.1 UL certification
Ind. Cont. Eq.
E115267
Products with this mark are tested by Underwriters Laboratories and listed as "indus-
trial control equipment". The mark is valid for the USA and Canada and simplifies the
certification of your machines and systems in this economic area.
Underwriters Laboratories (UL) per standard UL 508
Canadian (CSA) standard per C22.2 no. 142-M1987
UL certificates are available on the B&R website under
.
Note that the device is classified as "open type" when used in the area of "Industrial control equipment" per UL 508.
The device must therefore be installed in a UL 508-compliant protective housing as a requirement for certification
or operation per UL 508.
The front of the device satisfies IP65 (EN 60529) and "Type 4X indoor use only" (UL 50E) requirements.
10.2.2 EAC
Products with this mark are tested by an accredited test laboratory and permitted to
be imported into the Eurasian Customs Union (based on EU conformity).
10.2.3 UKCA
UK Conformity Assessed (UKCA)
All directives applicable to the respective product and their relevant standards are met.
Products with this marking are permitted to be imported into Great Britain (England,
Wales, Scotland).
Information:
The declarations of conformity are available on the B&R website (
loads > Certificates > Declarations of conformity
).
98
Automation Panel 9x3 User's manual 2.01
