B&R Industries Provit 5000, User Manual

Page: 295 / 400

294 Provit 5000 User’s Manual
Software • BIOS for System Unit with Socket 370
PM Control by APM
If Advanced Power Management (APM) is installed on your system, selecting Yes
gives better power savings.
Video Off Method
Determines the condition of the monitor when it is in Standby mode.
Video Off after
Determines the degree of power saving for Doze, Standby and Suspend modes
when the monitor goes into power saving mode.
MODEM User IRQ
If a modem is installed on your IPC, then you enter the interrupt used in this field.
If the system is in Powersave mode it is awoken again by a signal of this interrupt.
Doze Mode
With this option you can determine after which period of time without user activity,
the processor should be operated with reduced speed. Value range: 1 Minute to
1hour.
Standby Mode
With this option you can determine after which time of user inactivity, the built in
disk drive and graphic controller should be switched off. Value range: 1 Minute to
1hour.
Suspend Mode
With this option you can determine after which time of user inactivity, all the
system components (apart from the processor) should be switched off. Value
range: 1 Minute to 1hour.
HDD Power Down
With this option you can determine after which time of user inactivity the hard disk
should be switched off (if there are a number of hard disks in the IPC, then all are
switched off). Value range: 1 Minute to 1hour.
Note: B&R built-in hard disks switch themselves off independently after
45 minutes inactivity.