B&R Industries Provit 5000, User Manual

Page: 274 / 400

Provit 5000 User’s Manual 273
Chapt
er
6
So
ftw
are
Software • BIOS System for System Units with Socket 7 (ZIF)
AUTO All connected display devices are automatically
activated. If no display device is connected then the
monitor is activated
CRT Only the monitor is activated
FPD Only the display is activated
CRT+FPD The monitor and display are activated (simultaneous
mode)
FPD contrast The contrast of the connected display can be set. Attention: This
is only possible for LCD displays.
FPD brightness The brightness of the connected display can be set (possible for
both LCD and TFT displays).
If a value (e.g. 80%) is saved in the BIOS Setup then the BIOS
uses these each time the system is started, also when another
display is connected.
CAN Detected I/O Port
If a B&R interface board is installed in your IPC, then the I/O range is shown here.
See also the section "CAN Interface".
CAN Assigned IRQ
Here, an IRQ can be assigned to the CAN port of the interface board
(disconnecting the interrupt line). You can choose between the options NONE,
IRQ10 and NMI (Non Maskable Interrupt). See also the section "CAN Interface".
PCMCIA Detected I/O Port
The I/O address range of the PCMCIA port (Socket 1) is displayed on the interface
board. See also the section "PC Card Slot/ SRAM".
Hardware Security Key Detected I/O Port
The I/O address range of the Hardware Security Key is displayed on the interface
board. See also the section "LPT2 (Hardware Security Key)".