37
Copyright 3/20
Bandit
MODEL 1425
MAINTENANCE
SCREEN REPLACEMENT
DANGER
!
1. Loosen and remove the screen latch hook on
both sides. See below.
2. Remove the 6 mounting bolts from the retainer
plate on the radiator side that holds the screen
in place.
3. Slide the screen out through the slot on the
radiator side.
4. Be sure to clean the area where the screen
sets.
5. Start the new screen into the slot.
6. Push the screen all the way back into position.
7. Put the retainer plate back into place, tighten
and retorque the 6 mounting bolts to 75 ft-lbs.
(102 Nm).
Various screens are available for sizing the
product. Screens are a wear item on your machine
and should be checked frequently. If screens are
bent or broken, replace immediately. Failure to do
so will cause costly damage to your machine
.
Before attempting any type of maintenance,
disengage clutch, wait for the cutterhead to come to
a complete stop, turn off engine, remove the ignition
key, make sure the ignition key is in your possession,
wait 2 minutes and then disconnect the battery.
8. Insert and retighten the screen latch hooks on
both sides.
9. Open the cutterhead hood and very carefully,
manually with a pry bar or wood bar, turn the
cutterhead a full revolution to make sure there
is no contact between cutter teeth and screen.
10. Close the cutterhead hood, reinsert the hood pin,
and padlock the hood pin.
11. Reconnect the cutterhead hood door engine
disable plug and the battery.
Retainer
Plate
Screen
Latch Hook
NOTICE