Bandit The Beast 1425, Operating & Parts Manual

Page: 30 / 86

28 Copyright 3/20
Bandit
MODEL 1425 MAINTENANCE
Use as a reference only, locations may vary depending on options or component manufacturer.
Lubrication point instructions are described on the machine, in the Maintenance Section of this
manual or component manufacturer’s manual.
NOTICE
CHECK
# DESCRIPTION QTY DAY WEEK MONTH PROCEDURE
1 Feedwheel Bearings 2 X 2 - 3 shots of grease - wipe off excess
2 Infeed Conveyor Bearings 4 X 2 - 3 shots of grease - wipe off excess
3 Discharge Conveyor Bearings 4 X 2 - 3 shots of grease - wipe off excess
4 Feedwheel Drive Chain 1 X Dry lube
5 Cylinder Pins 2 X 1 - 2 shots of grease - wipe off excess
6 Infeed & Discharge Adjusters 2 X 1 - 2 shots of grease - wipe off excess
7 Yoke Arm Pivot Pin 2 X 2 - 3 shots of grease - wipe off excess
8
Steel Friction Areas: pivoting,
hinged, sliding, rolling.
X Lubricate
9 Cutterhead Bearings 2 X 16 pumps - wipe off excess
10 Pintle Eye Ring 1 X Grease to reduce wear
11 Tongue Jack 1 X 1 - 2 shots of grease - wipe off excess
12 Clutch Lubricate per MFG’s instructions
13 Axles Lubricate per MFG’s instructions
LUBRICATION CHART
1
6
2
2
3
9
7
8
6
3
13