26
Copyright 3/20
Bandit
MODEL 1425
MAINTENANCE
1. Check cutterbody bolt torque with a torque wrench: 700 ft.-lbs. (949 Nm).
2. Check and retorque wheel lug nuts.
3. Check infeed conveyor tightness.
4. Check discharge conveyor tightness.
5. Grease yoke arm pivot bushings with 2 to 3 shots.
6. Grease yoke cylinder pins with 2 to 3 shots.
7. Grease discharge conveyor chain adjusters with 1 to 2 shots.
8. Grease infeed conveyor chain adjusters with 1 to 2 shots (if equipped).
9. Lubricate steel friction areas: pivoting, hinged, sliding, & rotating areas
(i.e. cabinet doors, radiator screen hinge, engine adjusters, etc.).
10. Check alternator and fan belts on engine, adjust or replace.
11. Use a dry lube on top feedwheel chain driven components.
OK REPAIRED
WEEKLY CHECK LIST
Every week these checks must be made:
1.
Change hydraulic oil and flush the hydraulic tank.
2. Replace hydraulic suction screen(s) annually or every 2000 hours.
3. Drain and clean the fuel tank.
4. On machines built before 4/20, remove all grease from drum head bearings,
repack and fill housing 1/2 full.
OK REPAIRED
YEARLY CHECK LIST
Every twelve months these checks must be made:
1.
Replace hydraulic filter(s) after first 10 hours then quarterly or every 400 hours.
OK REPAIRED
3 MONTH CHECK LIST
Every three months these checks must be made:
OK REPAIRED
1. Grease cutterhead bearings every 120 hours or monthly with 16 pumps
of EP-2 Lithium type grease.
2. Check towing hitch for wear, keep pintle ring greased (if equipped).
3. Check discharge conveyor motor coupler torque.
4. Inspect infeed conveyor motor connections.
5. Check feedwheel teeth for sharpness.
6. Check, retighten all bearing and sheave bushing bolts.
7.
Check hydraulic function pressures. Set to specified PSI (bar).
8. Check and grease or oil wheel bearings, follow axle MFG. instructions (if equipped).
9. Check and adjust brakes, follow axle MFG. instructions (if equipped).
10. Check and adjust top feedwheel chain tension.
MONTHLY CHECK LIST
Every month these checks must be made:
