51806-001 en/2021-12
29 / 43
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
Perform Flush:
• Drain the contact liquid, see chapter 4.4.
• Fill the bucket with 4.75 l lukewarm water and 250 ml TICKOPUR TR 13
• Close the shut-o
ff
valve and
fi
ll prepared rinsing liquid -> oscillating tank can be
fi
lled
past the
fi
ll level mark, rinsing liquid may not
fi
t completely into the tank due to the
remaining contact liquid
• Set bath temperature to 40 °C and let the ultrasonic bath run for at least 1 h to allow
the liquid to heat up.
• Drain the rinsing
fl
uid
• Close the shut-o
ff
valve
• Fill several times with clear water
• Start-up for 5 minutes (with or without cooling)
• Drain the liquid, see chapter 4.4.
• Fill the ultrasonic bath with the appropriate contact liquid, if recommissioning is planned
If impurities still come out of the tube system during rinsing, it is recommended that
the tube system is
fl
ushed again
If
the
fl
ow continues to be well below 3 l/min after several rinses. send in the device for
maintenance ahead of time
6.1.3 Monitoring the ultrasound
• Insert a commercially available wattmeter between the mains plug of the ultrasonic bath
and the socket
• Fill the ultrasonic bath with liquid, see chapter 4.1.
• Switch on the ultrasonic bath
• Switch
o
ff
the cooling for a short time (setting of the target temperature must be at least
1 degree above actual temperature)
• Switch on ultrasound
• Compare the displayed measured value on the wattmeter with the technical data from
chapter 1.4 (tol/- 20 %)
• Switch
o
ff
the ultrasound.
• Switch on cooling (target temperature setting must be at least 1 degree below actual
temperature)
• Switch
o
ff
the ultrasonic bath
