4.6 Safety Infra Red Beam Option
A Safety Infra Red Beam Kit (Part No 62153) may be fitted to this opener.
•
When this option is fitted, the operation of this device is such that if an object (i.e. car, child, etc) blocks the
infra red beam, then the garage door opener will not close the door automatically.
•
If the Safety Infra Red Beam is fitted but not operating correctly, then the door once opened automatically, will
not close automatically. The door may be closed by reverting to manual operation – see manual Operation.
Refer to the Diagnostic Codes section of this Instruction Manual.
4.7 Auto Close Option
To have the Auto Close option you must also have a Safety Infra Red Beam (Part No 62153) fitted and functioning.
To enable the Autoclose function remove the light cover from the garage door opener and move the jumper that is
fitted in the J8 Connector to pins 1 and 2 (nearest the light globe).
When this option is selected the door will attempt to close automatically 30 seconds after opening.
If the Infra Red Beam is interrupted whilst the door is closing (for example by a person walking through the
doorway), the garage door opener will stop the door and reverse the door to the fully open position.
If the door does not close automatically, you may close the door using Manual Operation.
4.8 Remote Control Transmitter Battery
When necessary, remove the cover and replace the battery with the same type. Dispose of the old batteries
properly.
4.9 Changing the Light Globe
Your opener uses a 240 Volt, 25 Watt, standard Pilot Light globe. If you
should need to change a light globe, proceed as follows:
1.
Close the garage door to gain better access.
2.
Turn off the power at the power point.
3.
Remove the light cover – it is held in place by 2 phillips head screws.
4.
Remove the light globe and replace with a suitable new globe of the
same type and wattage.
5.
Refit the light cover.
6.
Turn the power on, and
7.
Press the operate button to ensure the opener is functioning correctly.
4.10 Courtesy Light
The Courtesy Light will illuminate for approximately 4
1
/
2
minutes each time the door is operated automatically.
Spare buttons of multi channel remote control transmitters (Smart Code or Dip Switch Code) or an entry keypad can
be programmed to turn the light on and off by remote control.
When the Courtesy Light is operated by a remote control transmitter it will turn off after approximately 4
1
/
2
minutes.
©Copyright 2003
19
Part No 059778
