2.6 Programming Optional Remote Control Transmitter Features.
You can program each button of your multi channel
remote control transmitter so that each button performs a
different function. You can program each button of a multi
channel remote control transmitter to activate one of the
following features:
•
To “Operate” the garage door opener – see Step 3,
•
to turn on and off the “Courtesy Light” independent of
door operation – see 2.7,
•
to activate the “Vacation Mode” – see 2.8, or
•
to operate the “Auxilliary Output” – see 2.9.
2.7 Code Setting “REMOTE COURTESY LIGHT”
Although the courtesy light comes on with each operation of the opener, the courtesy light may also be controlled by
a remote control transmitter without operating the opener. To code one of the remote control transmitter buttons to
turn the courtesy light on and off:
Press the Code Set
Press and release the Code Set button twice, the Code Set LED will start illuminate and
2 times
courtesy light will turn on to show that you are learning the code for controlling the
courtesy light.
Press the Remote
Choose a button on the remote control transmitter that is not coded into the receiver,
press this button whilst in courtesy light learning and the receiver will store this code.
The Courtesy Light can now be turned on or off by the coded remote control transmitter.
Note: Up to 12 “Smart Codes”, one “Dip Switch Code” and one “Keypad Code” can be stored to operate the courtesy
light.
2.8 Code Setting “VACATION MODE”
The opener can be programmed into a “Vacation Mode” where the opener will not respond to any remote control
transmitter as follows:
Press the Code Set
Press and release the Code Set button three times, the Code Set LED will illuminate
3 times
and the courtesy light will flash slowly (once every two seconds) to show that you are
learning the code to operate the “Vacation Mode”
Press the Remote
Choose a button on the remote control transmitter that is not coded into the receiver,
press this button whilst in Vacation Mode learning and the courtesy light will go out and
the Code Set LED will flash rapidly to indicate the receiver has stored this code.
“Vacation Mode” – you can only program one “Smart Code”, one “Dip Switch Code” or one “Keypad Code” to operate
this feature. It is recommended that a “Smart Code” remote control transmitter be used as the wall button within the
garage – program one button to control the “Vacation Mode” feature.
To activate the Vacation Mode facility, with the garage door in the closed position, press the coded remote control
transmitter. The Power LED will flash slowly to indicate that the opener is in “Vacation Mode”.
To exit “Vacation Mode” the opener should be operated from the Operate Button on the courtesy light cover.
©Copyright 2003
13
Part No 059778
SERVICE
POWER
For Product Support contact 1800 636 407
Patents Apply
Code
Set
LED
Code
Set
Button
