2.9 Code Setting “AUXILLIARY OUTPUT”
It is possible to operate other devices (eg alarm systems) using one of the spare buttons of a multi channel remote
control transmitter coded into the Auxilliary Output feature.
(Refer to Section 3.3 and 4.4 for description of the Auxilliary Output function).
Press Code Set
Press and release the Code Set button four times, the Code Set LED will flash slowly
4 times
and the courtesy light will flash quickly (twice per second) to show that you are learning
the code to operate the “Auxilliary Output”,
Press the Remote
Choose a button on the remote control transmitter that is not already coded into the
receiver, press this button whilst in Auxilliary output learning and the receiver will store
this code.
Note: Up to 12 “Smart Codes”, one “Dip Switch Code” and one “Keypad Code” can be stored to operate the Auxilliary
Output feature.
2.10 SETTING OPTIONAL REMOTE CONTROL TRANSMITTER DIPSWITCH CODES.
Some remote control transmitters have a dip-switch facility. Generally, dipswitches are used when several persons
are operating the same opener. The dip-switches must be set to matching positions in all transmitters used to activate
the opener.
•
Remove the battery cover.
•
Set switches in all remote controls to matching positions
(+, -, 0). Use a pen or screwdriver.
•
Replace covers and program this code.
2.11 TO ERASE PROGRAMMED CODES.
If the Code Set button is pressed and held on for 6 seconds, the
LED will blink rapidly for one second to indicate that all
programmed codes have been erased.
Permanently fix the label warning against entrapment and manual operation in a
prominent place or near any fixed controls.
After installation, ensure that the mechanism is properly adjusted and that the opener
reverses when the door contacts a 40mm high object placed on the floor under the
garage door – see Testing the Safety System.
AS3350
14
©Copyright 2003
Part No 059778
