Use caution when operating the manual release with the door open since it may fall
rapidly due to weak or broken springs, or an imbalanced door;
AS3350
Caution: Do not disengage the opener to manual operation with children, persons or
any objects including motor vehicles within the doorway.
2.5 PROGRAM THE OPENER
For the garage door opener to function properly the Door Travel
Limits, Door Travel Force Settings and Remote Control Transmitter
Codes will need to be programmed. If infra red beams are to be fitted
they should be installed and connected prior to setting door travel
limits.
For normal operation of the garage door opener there are 3 steps, for
optional advanced features see Programming Optional remote Control
Transmitter Features. To program the opener proceed as follows:
Step 1 Door Travel Limit and Door Travel Force Setting.
Door travel Limits have to be programmed into the garage door opener to set the desired range of movement of the
garage door. Whenever the Door Travel Limits are programmed the garage door opener will be forced to re-learn the
Door Travel Force and reset the Service Counter. Use the following procedure:
SERVICE
POWER
For Product Support contact 1800 636 407
Patents Apply
i. Check opener disengaged
The operator should still be disengaged, if not, disengage the opener by
pulling down the red handle.
ii. Move door half way
Manually move the door to a position at least one metre above the floor.
iii. Power on
Turn on the power to the opener (you may notice the CODE SET and LIMIT
SET lights will flash rapidly for a few seconds whilst the opener goes through
a diagnostic self-test)
The POWER LED will illuminate.
The Service LED may also be on.
iv. Press Limit Set button
Press and hold the LIMIT SET button (approx. 3 seconds) until the Limit Set
LED illuminates then release the button.
v. Move door to bottom limit
Move the door manually to the desired lower limit and press the LIMIT SET
button once to accept this bottom limit. The Limit Set LED will now be
flashing.
vi. Move door to upper limit
Move the door manually to the desired upper limit and press the LIMIT SET
button once to accept this limit. The flashing LED will go out.
(Alternatively, after setting the bottom limit in step (v) you can re-engage the
opener by pulling the red disengagement handle and press and hold the
Operate button on the light cover to drive the door to the desired open
position. When the desired open position is reached release the Operate
button and the opener will stop. Press and release the Limit Set button once
to accept this top limit – the flashing LED will go out.)
vii. Re-engage opener
Re-engage the opener by pulling down on the red disengagement handle.
viii. Press Operate Button –
Without obstructing the door:
Close the door then
• Press the Operate Button to drive the door to the bottom door travel limit,
open the door
then
• Press the Operate Button to drive the door to the upper door travel limit.
The opener learns the door travel forces during these movements.
• Repeat this process to drive the door down and up a second time.
x. Service LED Off
The “Service” indicator will now turn off to indicate that this step is complete.
10
©Copyright 2003
Part No 059778
