baltur 56495410, Installation, Use And Maintenance Instruction Manual

Page: 94 / 112

ENGLISH
38 / 54
0006081544_201907
MAINTENANCE
TBML 200
Analyse combustion gases and check that the emission values
are correct at least once a year, in compliance with current law.
• Clean air damper, the air pressure switch with pressure port and
the relevant pipe, if any.
• Check the electrode condition. Replace them, if necessary.
• Clean the photocell. Replace it, if necessary.
• Have the burner and the chimney cleaned by specialised
personnel (stove repairer); a clean burner is more efficient, lasts
longer and is quieter.
• Check that the fuel filter is clean. Replace it, if necessary.
• Check that all components of the combustion head are in good
condition, have not been deformed and are free from deposits
deriving from the installation environment and/or from poor
combustion.
• Analyse combustion gases and check emissions values.
If the combustion head needs to be cleaned, remove the
components following the procedure indicated below:
• Remove the holding nut and unhook the gas throttle control
lever (26).
• Disconnect the diesel hoses (24) from the connectors beneath
the head unit (mind the dripping).
• Unscrew the two screws (12) and turn the burner around the pin
(31) in the hinge.
• After pulling the ignition and ionisation cables (14) out of their
electrodes, unscrew the locking nuts (6) from the mixing unit.
Loosen nut (9) and completely unscrew the fastening screw on
the delivery coupling (19).
24
12
31
26
0002937090