baltur 56495410, Installation, Use And Maintenance Instruction Manual

Page: 68 / 112

ENGLISH
12 / 54
0006081544_201907
BURNER CONNECTION TO THE BOILER
HEAD UNIT ASSEMBLY
• Adjust the position of the coupling flange (19) by loosening the
screws (6) so that the burner head enters the furnace to the
extent recommended by the generator manufacturer.
• Position the insulating gasket (13) on the sleeve, by inserting
the cord (2) between the flange and the gasket.
• Fasten the head unit to the boiler(1) by means of the stud bolts,
washers and the nuts provided (7).
DANGER / ATTENTION
Seal the space between the burner sleeve and the hold on
the refractory material inside the boiler door completely with
suitable material.
ASSEMBLING THE GAS TRAIN
There are different ways of assembling the valve train, as shown
in drawing 0002937060.
Choose the most rational position for the set-up of the boiler room
and the position in which the gas pipeline arrives.
DANGER / ATTENTION
In case of very large valves, e.g. DN65 or DN80, make sure
there is a suitable support to prevent excessive stress on
the gas train fitting.
ASSEMBLY OF VENTILATION SYSTEM
Position the half-hinge on the burner scroll in line with those on the
combustion head assembly.
• Insert the hinge pin (10) in the position considered most suitable
• Connect the cables (switch on and ionisation) to the
corresponding electrodes, close the hinge, locking the burner
by means of screws (11).
• Insert the gas throttle control lever on the shaft and block it with
the specific nut.
COMPLETING BURNER SETUP
• Remove the protective (yellow) caps from the fittings placed
beneath the head unit and near the solenoid valves.
• Connect the light oil pipes (24) provided with the burner to
their corresponding connectors, making sure they are properly
sealed.