Care2
Installation Instructions
38
Care2 issue 7
4.3 S
OFTWARE
C
OMMISSIONING
P
ROCEDURES
4.3.1 Initial Commissioning using SD CARD
For the MASTER Console or a Single Non-networked Console:
1. Ensure the Basic Hardware Commissioning Procedure shown
in Section 4.1 is completed successfully.
2. Disconnect the Power to the Console & remove the SD Card.
3. Insert the SD card into a PC running the SD Configurator
Spreadsheet.
4. Set the correct Data Path for the SD Card (see Section 5.2.4
on page 61).
5. Fill in details for ALL Outstations on the System and not just
Local Outstations on the Master Console (see Section 5.2.2
and Section 5.2.3 on page 59).
6.
Ensure the Master Console (Console #1) is selected
on the ConsoleConfig Page.
Complete the Configuration details for the Master Console
(see Section 5.2.1 on page 58).
7. Save the spreadsheet (identifiable as the Master Console
spreadsheet) to a known location as this contains
the
configuration data for all the outstations and
the settings
specific to the Master Console
.
8. Select the “Save ALL Config / Data” to SD Card option (see
Section 5.2.6 on page 61).
9. Using the USB options on the PC, eject the SD Card to
enable safe removal of the device then remove the SD Card.
10. Ensure the Console is not switched on & insert the SD Card.
Apply Power using either Mains or the internal Batteries.
11. Clear Device Assignments (see Section 7.6 on page 81).
12. Initiate the Internal Device Detection procedure (see Section