Care2
Installation Instructions
Care2 issue 7
39
For the SLAVE Console & All NEP Consoles:
1. Ensure the Basic Hardware Commissioning Procedure shown
in Section 4.1 is completed successfully.
2. Disconnect the Power to the Console & remove the SD Card.
3. Insert the SD card into a PC running the SD Configurator
Spreadsheet.
4. Set the correct Data Path for the SD Card (see Section 5.2.4
5. Load either the “Master” console configuration spreadsheet
(as saved in step (7) of the Master Console Commissioning
procedure), or the Console Specific spreadsheet if it is
available.
6. In “Console Address” select the relevant Console Number
(see Section 5.2.1 on page 58).
7. Complete the Configuration details for the Slave (or NEP)
Console (see Section 5.2.1 on page 58).
8. Save the spreadsheet (identifiable as the relevant Slave or
NEP console) to a known location as this contains
the
configuration data for all the outstations and
the settings
specific to the Relevant Console
.
9. Select the “Save ALL Config / Data” to SD Card option (see
10. Using the USB options on the PC, eject the SD Card to
enable safe removal of the device then remove the SD Card.
11. Ensure the Console is not switched on & insert the SD Card.
Apply Power using either Mains or the internal Batteries.
12. Clear Device Assignments (see Section 7.6 on page 81).
13. Initiate the Internal Device Detection procedure (see Section
4.4 on page 43) and ensure it is successful.
14. Connect the local Network Connections (see Section 2.4.2
on page 22) to the network card.
15. Repeat steps (1) to (14) for the Slave & all NEP Consoles.
Note: Perform a System Reset on the MASTER Control Panel after all
other panels are configured and connected.
