Care2
Installation Instructions
Care2 issue 7
53
4.8 R
OAMING
T
ELEPHONE
E
NCLOSURE
S
PECIFIC
P
ARAMETERS
The Console monitors the handsets within the Enclosure and will
announce a Warning if a Handset is removed, but it is necessary
to set the threshold for the number of handsets in use.
1. Follow steps (1) to (6) of the Auto Assign Procedure
(page 45) to open the “Line Parameters” menu.
Figure 4.25 — Line Parameters Menu showing Lines 1-4
2. Scroll up or down to highlight the Line with the Enclosure
(Line 2 in this example).
Figure 4.26 — Highlight the Required Line
3. Press the encoder and the parameters for that Line will then
be displayed.
Figure 4.27 — Parameters for Line 2
4. Scroll down until EOLz OC (End Of Line Impedance Open
Circuit) value is shown, and press the encoder.
The default value for a single Roaming Handset is 400uA.
