Baldor NextMove ST, Installation Manual

Page: 47 / 72

www.supportme.net
Operation 5-5 MN1929
3. In the Select Controller dialog, go to the drop down box near the top and select the PC
serial port to which the NextMove ST is connected. If you are unsure which PC serial port
is connected to the drive, select
Scan all serial ports . If the NextMove ST is connected
using USB, it will be scanned automatically.
Click Scan to search for the NextMove ST.
When the search is complete, click NextMove ST in the list to select it, and click the
Select button.
Note: If the NextMove ST is not listed, check the serial or USB cable between the
NextMove ST and the PC and that the NextMove ST is powered correctly. Click
Scan to re-scan the ports.
4. A dialog box may be displayed to tell you that WorkBench v5 has detected new firmware.
Click OK to continue. WorkBench v5 reads back data from the NextMove ST. When this is
complete, Edit & Debug mode is displayed. This completes the software installation.