16
OWNER’S MANUAL |
THERMOMASSEUR
®
1 800 463.2187
From 8 a.m. to 8 p.m. Monday to Thursday (EST) . From 8 a.m. to 5 p.m. on Friday (EST)
Printed in Canada. Copyright © January 2011 BainUltra Inc. All rights reserved. 45220001
Some products, specifications, and services mentioned in this manual are described in pending patent applications or are protected by patents.
THERMOMASSEUR
®
2. INSTALLATION
2-1
Install the drain and overflow set on the
bath and the first section of the air intake
pipe (1 1/2’’ ABS) under the floor.
2-2
Apply a silicone joint to the base rim.
2-3
Put the ThermoMasseur
®
in place and put
pipes through the floor, ensuring bath is
aligned with anchoring points.
2-4
Wipe off excess silicone immediately.
Once plumbing is fully installed and before beginning
any other work, fill the ThermoMasseur
®
to overflow
and wait 30 minutes. Check all plumbing hook-ups
and bath for leaks.
BainUltra
®
is not responsible for
any water damage caused by improper installation
(see Warranty section)
.
Install turbine and InMix power module connections
according to specifications outlined in the
MIAMULTI
®
ELECTRICAL INSTALLATION - TURBINE
section.
LEAK TEST
ELECTRICITY
BALNEO
®
- NAOS & SANOS
INSTALLATION
1. BATH SITE
1-1
Once the floor has been finished and is
perfectly level, place ThermoMasseur
®
in
the exact chosen location. Trace the outline
of the bath with an erasable marker.
1-2
Remove the ThermoMasseur
®
and carefully
place it upside down on a blanket or
corrugated cardboard (ex. the box in which
it was delivered).
1-3
On the floor, determine by referring to
measurements taken underneath the bath,
the exact location of the drain, the air pipe,
and the two anchoring points at each end
of the bath.
NOTES
• Since these models sit directly on the floor, the overflow drain pipe opening is factory-drilled.
• To installation of the Naos or Sanos on a concrete slab with no access below for air entry to the
bath: a hole of 1 5/8 inch (4.1 cm) in diameter must be drilled into the bath skirt to allow air
supply to the bath. Important: Do not drill above height of existing hole in the skirt intended to
connect drain to overflow.
BALNEO
®
- NAOS & SANOS - INSTALLATION
2-1
2-2
2-3
1-1
Horizontal – Drain
Horizontal –
Anchoring
Point
Vertical –
Drain
Vertical –
Anchoring
Point
Vertical –
Air Intake
Pipe
1- 3
TOP VIEW