INSTALLATION
FUNCTION CODE 55 CONFIGURATION
I-E96-322A
3 - 11
FUNCTION CODE 55 CONFIGURATION
If the jumpers and dipswitches in this section are set up for
operation with function code 55:
1. Configure the multi-function processor with function
code 55. Refer to the
Function Code Application Manual
for
information on how to configure function code 55.
2. Tune the demodulator gain, calibrate the LVDT trans-
former, and tune the PID controller gain. Refer to
for
procedures explaining how to do either automatic (demodula-
tor gain only) or manual calibration and tuning using function
code 55.
FUNCTION CODE 150 CONFIGURATION
If the jumpers and dipswitches have been set up for operation
with function code 150:
1. Refer to the
Function Code Application Manual
for infor-
mation on configuration instructions.
2. Configure the processor module with function code 150,
specifications S1 and S2.
3. Leave the remaining specifications at their default values.
They require modification during the module calibration proce-
dure. Refer to
to calibrate the LVDT transformer
and tune the PID controller gain using function code 150.
