INSTALLATION
OPERATOR INTERFACE DEVICES
3 - 22
WBPEEUI220760A0
®
3. Connect the cable to the touch screen controller card. Note
that pin one on the cable has the red stripe.
4. Attach the touch screen controller card to the MKM card
with the four nylon spacers and screws.
5. Repeat the procedure if installing a second kit.
CALIBRATING THE TOUCH SCREEN
On-line calibration can be done from the console. For operating
information, refer to the
Operation
and
Configuration
instructions (Table
).
TOUCH SCREEN JUMPER SETTINGS
Jumpers J6 through J9 on the IIMKM02A keyboard module
control the touch screen accessory (Fig.
).
1. For OIS consoles with upper or lower monitors, set jumpers
J6 and J8 at 1 to 2.
2. For OIS consoles with dual monitors, set jumpers J6
through J9 at 1 to 2.
Figure 3-18. Touch Screen Controller Card Connections
TOUCH SCREEN CARD 1
TOUCH SCREEN CARD 2
COMPONENT SIDE
IIMKM02
P14
P15
TP27322A
