COMPONENT DESCRIPTION AND REPLACEMENT
OPERATOR INTERFACE DEVICES
6 - 22
WBPEEUI220760A0
®
board interface assembly at the MOUSE/TRACKBALL port.
Unplug these devices to remove them.
Annunciator Display Panel
There are two types of annunciator display panels available for
the OIS consoles. They are the IIADP01 and the IIADP02. The
IIADP01 annunciator display panel is a tabletop unit, the
IIADP02 mounts in the cabinet on the front of the console.
They provide 32 LEDs and pushbuttons. Each LED may be
assigned to a tag. When a tag goes into an alarm condition, the
assigned LED flashes until acknowledged and then turns solid.
Ribbon cable maximum length is 4.5 meters (15 feet).
IIADP01/02 Removal
The console comes with the IIADP02 mounted in the console.
To remove the ADP refer to Figure
and follow these steps:
1. Turn off the main circuit breaker on the power entry panel.
Check the main power indicator to see if power is removed.
2. Turn the two screws 90 degrees to remove the ADP panel
from the bezel. Remove the ADP panel.
NOTE: If it is necessary to remove the bezel, remove the four
screws securing the bezel to the console.
3. Disconnect all the cables.
The ADP01 tabletop unit can be added to the OIS console in
addition to the ADP02.
4. To remove an IIADP01 tabletop unit, unplug the cable.
Refer to
installation information that includes access switch settings
for the new ADP panel.
