COMPONENT DESCRIPTION AND REPLACEMENT
OPERATOR INTERFACE DEVICES
6 - 26
WBPEEUI220760A0
®
2. Remove the SCSI cable and the two power cables from the
rear of the floppy drive. Carefully pull the floppy disk drive out
the front of the console.
Refer to Figure
for the correct SCSI switch setting.
Color Monitor
Resolution for the OIS high resolution color monitor is 1280 x
1024 pixels. Adding additional color monitors is model depen-
dent.
Refer to Figures
and to Table
for the
OIS console and driver cabinet monitor cable connections.
To remove a lower monitor from a console, follow these steps.
1. In the front of the cabinet, turn off the main circuit breaker
on the power entry panel to shut off power to the console.
Check the power indicator to see if power is removed from the
system.
2. Remove the power cord and VGA cable from the rear of the
monitor. Secure the VGA cable out of the way.
3. Remove the bolt on each side of the monitor mounting tray
at the rear of the monitor. These bolts attach the tray to the
cabinet shelf.
Figure 6-17. Floppy Drive SCSI Switch Setting
FLOPPY DRIVE
- OFF -
1
2
3
TP80658A
SCSI ID = 2
WARNING
The monitor will slide out the rear of the cabinet by itself when
the mounting bolts are removed. The monitor weighs approxi-
mately 27 kilograms (60 pounds) and can cause bodily injury if
it is allowed to slide out by itself. Support the monitor before
removing the rear two bolts.
AVERTISSEMENT
Supportez le moniteur avant de retirer les deux boulons
d'ancrange à l'arriér. Lorsque ces boulons d'ancrage sont
retirés, l'e moniteur glissera et sorta à l'arriér de l'armoire. l'e
moniteur pése environ 27 kilograms (60 pounds) et pourrait
entrainer des blessures si on le laisse glisser de l'armoire.
