INSTALLATION
PERIPHERALS
3 - 36
WBPEEUI220760A0
®
3. For consoles, the IIDMT03A is used as a tabletop unit.
Attach the external SCSI cable (Table
), one end to the
tape drive SCSI port and the other end to the peripheral port
on the power entry panel.
4. For driver cabinets, remove the cover plate from the front of
the power entry panel. The power entry panel has a support
tray that enables mounting the IIDMT03A into the rack.
Remove the hook velcro strip from the support tray: the loop
strip will remain on the tray. Remove the adhesive backing
from the strip of velcro and apply the strip to the underside of
the tape drive. Position the tape drive in the tray. There is an
internal SCSI cable with multiple connectors in the driver cabi-
net. Connect to the SCSI port on the tape drive.
5. Connect the supplied power cable from the tape drive to a
local power source.
6. Verify that the green LED is ON.
7. Apply power to the OIS.
IIDOP04A and IIDOP05A Optical Disk Drive
Two optical disk archiving units are available. The console uses
the tabletop IIDOP04A optical disk. The driver cabinet uses the
rack mounted IIDOP05A optical disk. If an additional
IIDOP05A is required, order part number 1949017 1 and
1947950 2 (power cord) to receive the optical disk unit with-
out duplicate mounting brackets and hardware.
The RWZ52 optical disk drive is a SCSI compatible storage
device that reads and writes to removable disks. Next to the
button is the emergency eject hole for removing disks
without power. An eject tool is provided with the unit.
NOTE: The OIS43 only supports the rewritable media format at
1,024 bytes per sector.
There are two hardware settings that must be made to the opti-
cal disk drive; the SCSI address setting and operation mode
setting. Set the SCSI address using the following steps.
1. Make sure the power to the optical disk drive is off.
2. Locate the SCSI ID switch on the rear panel of the disk
drive.
3. Set the SCSI ID by pushing in on the button on the rear
panel that is directly above or below the address window with a
small screwdriver or the point of a pen. A small screwdriver is
shipped with the unit. The button above the window decreases
EJECT
